Paintless Dent Removal

Common Questions About Paintless Dent Removal

Paintless Dent Removal, also called paintless dent repair, refers to a technique of repairing small dents in the exterior of a car. Since paintless dent removal requires the removal of outer layers of the car’s paint in order to access the dent, the entire process can be completed inside of the car, rather than on the exterior. Paintless car repair can also be used on steel and aluminum panels with dent problems.

The parts involved in this type of car repair are some of the most basic equipment that any shop would have on hand. Special tools include special brushes that are used to clean the dirt away from the areas where dents are located. Depending upon the size of the dent, technicians would use either soft or hard bristles to brush away the dirt from the back side of the dent. Special tools and brushes are used by technicians to carefully remove the excess metal from around the dent. In addition to these tools, paintless dent removal technicians would also have access to various chemicals that are used to help seal the dented areas. These chemicals can be purchased over-the-counter in most stores.

The dents most commonly repaired by paintless dent removal technicians can range from dents in the hood of an automobile to dents in the backside of vehicles. While the majority of dents can easily be repaired with household tools, there are some situations in which repairing a dent is impossible. For example, most vehicles have dents caused by sharp rocks or other road debris that scrape against the underbelly of the car. In these cases, repairing a dent is nearly impossible because the damage would require extensive repairs. Other instances in which paintless dent removal is necessary include small dings that occur on the hood or trunk of a vehicle as well as dents that are caused by parking problems or bumps in the road.

Before undergoing paintless dent removal, it is important to understand some of the common questions asked by technicians working in this field. Common questions include questions regarding the procedure itself and after care. Both of these topics are quite simple and can be answered with basic information. In some situations, technicians will need to temporarily close a vehicle to check for possible leaks or other problems. This is usually done to ensure that the vehicle is not damaged further or to prevent any further damage from occurring.

After paintless dent removal is performed, technicians often use sealants or adhesives to repair the damaged area. If the damage is on an interior surface, technicians use a penetrating solvent that penetrates the affected area and bonds with the metal. After this process, technicians may apply a thin coat of primer to the damaged area, cover it with a fiberglass body panel and sand it. A high-pressure air is used to blast the primer and body panel back into shape.

Commonly, after paintless dent removal the vehicle’s engine is covered until it is safe to drive, typically about four hours. The vehicle is then examined by the insurance company to ensure that there are no other damage or repairs to the vehicle that would preclude it from obtaining insurance coverage. In cases where the damage is widespread and impossible to repair, the vehicle is sent to a paintless auto repair shop to be repaired or replaced with a new one.